I am really excited to be sharing my first of hopefully many more craft how-to posts, especially when it comes to the Cricut. I recently shared an Instagram post of a shadow box I had filled with 3D flowers, and a few people have inspired me to write by asking how to make these.
You may of reading my post recently about my excitement of being brought the Cricut explore air 2 recently, why I think the Cricut is any crafters best friend.
my opinion is still so strong on how much I love this crazy crafty machine.
Since I have been playing around in the world of Cricut I have absolutely loved creating shadow boxes full of colourful 3D flowers. As much as I love playing with vinyl, this is one of my favourite projects to do. These flowers are so very simple to make.
What you will need:
- Card stock
- hot glue gun
- Your Cricut
The time needed to make:
depending on how many flowers you are intended in to make. I would allow a few hours for this project. Individually each flower takes approximately 5 minutes.
You will need to print your flower swirls from the Cricut projects. You can use the flowers guide that’s available in the projects here. I have opted to only print this one of the three in the project as it makes rose flowers, which is my favourite. For this shadow box, I have used A4 card stock, and fitted 6 swirls to a sheet, this did result in the flowers being quite small, however, you can make these any size that you like. Why not try experimenting with sizes?
If you don’t own a Cricut you could try making a stencil and cutting these out with scissors, unfortunately, it will take some time though.
Remove the excess paper from your rose swirls. So that you are left with just the cut-outs… now it’s time to turn the swirls into flowers! I keep a craft knife by me ready to cut anything that may not have cut completely with the Cricut. It depends on the thickness of the card most of the time.
I prefer to use slim tweezers to start turning. Grasp these to the very end of the swirl. (Leaving the centre bit for last) twist the card around the tweezers basically rolling up the card until you read the end.
Once you have finished turning your swirls, You will need to position the centre at the top so that you can secure your flower together.
Add a pea-size amount of hot glue to the bottom of your flower and press this down with your fingers for about 20 seconds…
My top advice would be to be careful with your fingers. I have burnt my fingers making roses many times.
What to do with them…
there are plenty of things you can use these beautiful flowers for. As I mentioned before my favourite is a shadow box, and then vinyl on the glass. But you could also use these to decorate the outside of frames and mirrors.
I have recently started an Instagram page for me to share all my crafty shenanigans on called crafty hearts corner, so if you would like to see more of what I am up too with craft, give this a follow.
- Why I think The Cricut Explore Air 2 is any crafters best friend
- 5 reasons the craft world can help your mental health.
- Desk goals? What’s on my desk!
- Crafter life – You know you are a crafter when…
- 11 Ways to make extra money working from home.